Wiring Help

[chinny]

I just received my AudioBahn A2502DP amp today and iam going to pair it along with 2 AudioBahn 12's AW121T 550W RMS / 1100W / single voice coil. I was wondering what will be the best wiring that i can do for this combo.

Amp-
RMS Power (4 ohms) 250 watts x 2 ch.
RMS Power (2 ohms) 500 watts x 2 ch.
RMS Power (1 ohm) 750 watts x 2 ch.
Bridged RMS Power 500 watts x 1 (4 ohms); 1000 watts x 1 (2 ohms)

I was wondering how to wire my subs in a 2 ohm load, i already wired them in a Q-Logic ported box.

Sub-
http://www.sonicelectronix.com/item_1461.html thats all the info for it. To make the question simple, how do i wire into a 2 ohm load to atleast get 1000w rms out of the both subs?

:help:

[Jszar]

well, they are 4 ohm subs. if they are ran parallel into the bridged channel, that will give you a 2 ohm load, and the supposedly 1000w rms the amp supposedly produces. I doubt that is RMS power btw, i looked it up and it didnt mention either RMS or MAX....that usually means its max and they just don't want to say.

[chinny]

Its RMS, ive checked and doubled and checked about 10 times, peak power its said to be 3000W Approx. To wire it in parallel would i have to take the subs out of the box and and re wire them ?

[William from NOLA]

Peak power is meaningless. RMS is what you should be concerned with.

Wiring them in parallel is just hooking each + and - to the + and - of the amp. A series wiring would involve wiring the subs to each other. To bridge the amp, follow the directions in it's manual or printed by the speaker terminals. *Note* both +'s and -'s will have to go to the same spot from each sub.

[chinny]

Iam not a total nub to this, but i was just making sure, i didnt want to burn my system :(