brake problems... again.

[Scarrell]

well s10 forum isnt being very helpful.. so i thought id post on here.. does anyone know if a 1988 or 2000 s10 brake master cylinder will fit on my 96 s10, i got a couple buddies willing to sell me one for cheap off of either, but i told them i think only 95-97 will fit but im not sure? my brakes went out and my master is leaking all over...etc.. does anyone know what all needs to be done when replacing it?

[Ryan from Ohio]

To see if it will fit go to Autozones website and get a part number for your year/model. Then look up the other trucks in questions year/models. If its the same part, then it should work.

When you change these you will pretty much need to bleed each brake line at the cylinders at each wheel. It sucks.

[cargodz]

To see if it will fit go to Autozones website and get a part number for your year/model. Then look up the other trucks in questions year/models. If its the same part, then it should work.

^ Exactly what I was gonna recommend when I read it :thumbsup

[Bwcad1]

96 and up will work.

[Purple RS]

Going through all that with my 89 RS Camaro now. I swapped out the rear axle for one with disc brakes and a slightly better posi gear (3.23 over 3.08), now I'm at the front end doing the new adjustable proportioning valve and a 4th gen master cylinder. Bleeding that system is going to be a PITA since it now has air throughout :argh