On the radar
Chevrolet
Camaro
(1986)
— Mullet
Running Remote and RCA Cables: To Rear of Car
Parts used in this build
No parts listed for this build.
This was a quicker project compared to some of the others, but very important none-the-less. I needed to run my RCA cables and the remote wire from the radio to the rear of the car.
Matching All Maximum Input And Output Sizes For Project
As I mentioned in my introduction “Planning” post for this project, I decided to go with the largest wire sizes possible. That means that because the amp inputs are sized for a whopping 6ga remote, that's what I am using! Is it ridiculous? Absolutely.
Ran Along Driver Side And Under Carpet
As usual, I am very OCD and therefore the wires are perfectly hidden all the way back, under the carpet and plastics. Because I ran the power along the passenger side, I am running the RCA and remote along the driver side to hopefully avoid as much interference as possible.
