by JeremyC » Tue Jul 09, 2013 6:02 am
4 Gauge you will need a separate grommet.
I would start with the power wire. Take as much of the interior out as you can, open the hood, and find a spot you can drill a hole in the firewall to run the power wire through. Make sure you check both sides of the firewall before you drill. I almost always run the power wire on the same side of the battery, but sometimes there just isn't room.
Run the wire through the new hole, slide your grommet into place, and add a little silicone to make a seal.
Now run the rcas down the other side along with the speaker wires.
But the interior back together.
4 Gauge you will need a separate grommet.
I would start with the power wire. Take as much of the interior out as you can, open the hood, and find a spot you can drill a hole in the firewall to run the power wire through. Make sure you check both sides of the firewall before you drill. I almost always run the power wire on the same side of the battery, but sometimes there just isn't room.
Run the wire through the new hole, slide your grommet into place, and add a little silicone to make a seal.
Now run the rcas down the other side along with the speaker wires.
But the interior back together.