Car Audio Central - Ultimate Car Audio Forum and Community

400x2 @ 2 ohms

thanks for the imput, Where would you get a finishing resin, the waxy layer is there to act as a type of filler right? to even out low spots

400 x 2 rms, yea i thought it was too cuz i realy havent seen too many amps capable of that

I have a kenwood 1600w class D amp, it has two channels, its pushing 2 12 inch single coil eclipse subs, what is the most effective way to wire it up? should i just go, 2ohm and one sub to each channel, 2 ohm bridge, 4 ohm bridge, or what, ive tried a few things right now i have it at 2 ohm bridged....

Do you use a laminating resin as a finishing layer with a fiberglass only box as well? also i was wondering, you had mentioned spraying the resin on. Is there a specific type of resin you use through a spray gun, or is it a type of gun, or do you just thin it enough to run through a typical HVLP pai...

I think i might try going with the normal fiberglass aproach, like with the base layers, just fiberglass cloth, and then try putting a few layers of the carbon fiber mat down and see if the look turns out right. Then would you sand and clear coat or gel coat the smoothed carbon fiber? i mean cuz you...

Question.. Has anyone heard of, or even made themselves, a box out of carbon fiber, as far as i understand it is applied much as fiberglass is,( correct me if im wrong). I just thought it would look cool as wel as be very durrable, because isnt carbon fiber stronger per layer, than fiberglass? Thanks