Car Audio Central - Ultimate Car Audio Forum and Community

Its a 1999.

dont listen to am? thats my suggestion. :) I knew I would get that from someone. LOL It is a Dodge Ram 1500 pickup and the amp is grounded to the seatbelt bolts. The radio is grounded to the factory harness ground wire. Over the weekend I will ground the radio to the seatbelt bolt and see if that h...

I have a high pitched whine when I listen to am radio even when the car is not running. I checked the ground at the amp and all is good (12.99 volts) without the alternator. The radio is powered by the starter battery and the amp is powered by the deep cycle battery. Both are grounded to the chassis...

Thanks. Should I set it to minimum or stick with the DMM setting?

Can someone please explain the reason and benefit of step #6? I originally set my levels with a DMM and now I’m being told to set them to minimum. What gives? 1) Set your source units fader and balance controls to their center positions. 2) Disconnect the output RCA connections between your DQT and ...

What software did you get? I am also looking for something simple and easy to use.

http://www.bcae1.com/battiso.htm The SR200 is a "continuous duty solenoid" relay that is perfectly suited for dual battery setup. In the event of a failure some diode isolators will combine the batteries causing both to drain. If the SR200 fails the batteries remain seperated. If you are ...

:i did read something on batt on this forum it had it`s pros&cons for deep cycle batt .but at the end it said better to use a starter batt.sense my stereo system has it`s own alternator :happy055: to charge the batt under the hood. It will be cheaper for now to get another batt like it than to ...

My Stinger 200 is triggered by my cigarette lighter (switched) circuit. Plus I have the Relay-delay that only combines the batteries when my alternator is charging at > 13.3 volts. My second battery is a deep cycle as suggested by GlassWolf. I also added a momentary switch so the deep cycle battery ...

This is my setup. I hope this helps.
http://www.dodgetalk.com/forums/showthread.php?t=128210