Bluerprints

[97Expoman]

I have 2 12" kicker compvr's and want to know if anyone has blueprints for making a dual vented box for these. My manual does have blueprints but it is for single enclosure only. This will be going in a 97 expedition. Any help would be greatly appreciated.

[97Expoman]

Is there adifference between vented and a slot-ported box? Sorry I am new to this whole thing and just wannna make sure I understand correctly.

[ridr4lif]

Hmm, i think for 20 bux Justin from Detroit offers blueprints.
An easy way to figure it out is just double the airspace and use 2 ports.
Vented and slot ported are the same thing.

edit:http://www.darkscience.com.au/caraudiohowto/slotcalc/
that is a port calculator. Enter in the airspace needed, height and width of port and play around with the length until you get the right frequency. Good luck!

[High Society]

And it should only cost about $30 to build the box yourself too.

[97Expoman]

Is there a differnce in sound using slot vented or round tubes for ports? I can make the box if I have blueprints. I will try to contact Justin from Detroit to see what we can come up with.

[Darthness]

you already have the blue prints.. just what they say. if you port it, make 2 ports.

[smoker]

basically for ported you want to make two seperate enclosures ideally......even if it is one unit you should divide the enclosure

[97Expoman]

So are you saying make the one box and use one of the ends as the divider and then build on to that side?? Sorry I don't mean to sound stupid but this is exactly what I am confused with.

[smoker]

either that or build it as one piece and divide it in the middle

[97Expoman]

Here is a link of the single box I am trying to build for 2 subs. The one I want is on page 27. http://www.kicker.com/05/tech-support/m ... alV2_1.pdf