Page 2 of 4
Posted: Sun Sep 18, 2005 7:34 am
by thehardknoxlife
It doesnt really matter because im going to run 1 dvc 2ohm sub in a 4ohm load so there is no need to drop the amp down below its reccomendations. It still puts out 600 watts at 2 ohms though. Read in the tech support about the titanium amps.
Posted: Sun Sep 18, 2005 7:58 am
by smoker
so its like a jl / series where the power output is the same at any acceptable ohm?
Posted: Sun Sep 18, 2005 10:30 am
by ridr4lif
Why not just run a single 12...like the Resonant engineering recommended before in a nice ported box? that should get pretty darn loud.
tedd
Posted: Sun Sep 18, 2005 11:13 am
by GlassWolf
Resonant Engineering SE 12"
dual 2 ohm coils standard
600 watt RMS power handling.
$169 each
fits what you want.
good sub.
Posted: Sun Sep 18, 2005 12:04 pm
by High Society
Get the 15 :)
If there isn't a dealer in your location, I think you can buy direct from RE.
Posted: Sun Sep 18, 2005 12:11 pm
by Ryan from Ohio
But your ahead to buy from Marshall @
http://www.visionaryaudio.com as the RE sales price is the price you pay shipped. If you buy from RE you need to pay shipping...
Posted: Sun Sep 18, 2005 6:52 pm
by thehardknoxlife
the amp is 150 x 2 @ 4 ohms 300 x 2 @ 2 ohms stereo 600x1 @ 4 ohms bridged
Posted: Sun Sep 18, 2005 6:53 pm
by thehardknoxlife
Basstronics wrote:But your ahead to buy from Marshall @
http://www.visionaryaudio.com as the RE sales price is the price you pay shipped. If you buy from RE you need to pay shipping...
I couldnt find that sub on that link
Posted: Sun Sep 18, 2005 6:57 pm
by thehardknoxlife
KikiTheCat wrote:Resonant Engineering SE 12"
dual 2 ohm coils standard
600 watt RMS power handling.
$169 each
fits what you want.
good sub.
It says that all the RE SE are DVC 4 ohm on the RE site
Posted: Sun Sep 18, 2005 7:09 pm
by ridr4lif
What about an Adire Audio Tempest (the new ones) if you can find a dealer near you.
http://www.adireaudio.com
tedd