Page 1 of 2
Speaker in PVC
Posted: Sat Jul 08, 2006 9:25 am
by Steven
Anyone know if it would be worth taking out my front door speakers and putting PVC pipe in the door speaker holes and putting the speakers back over the PVC ( airtight) if it would bring out the bass? They are Focal speakers, thanks.
Posted: Sat Jul 08, 2006 9:38 am
by Ryan from Ohio
Ok so you want to put PVC pipe int the area where your speaker goes and then put your speaker where?
Makes no sense?
Posted: Sat Jul 08, 2006 9:43 am
by Steven
Take PVC, put a cap on the back side, sealed and put the speaker on the front side, sealed. Making a enclosure.
Posted: Sat Jul 08, 2006 9:44 am
by sinister audio
it would work but why use PVC pipe?
Posted: Sat Jul 08, 2006 10:13 am
by Steven
What else would you use?
Posted: Sat Jul 08, 2006 10:27 am
by sinister audio
just use a wood baffle and have it IB, make a kick panel out of fiberglass.
Posted: Sat Jul 08, 2006 12:44 pm
by GlassWolf
the speakers are made for an infinite baffle setup. sealing them in a small container that way will make them sound much worse inf act.
If you want more low end from them, add an amplifier.
it takes an ample amount of power to make a driver move much air.
Posted: Sat Jul 08, 2006 1:08 pm
by MobileAudio219
and add some sound deadner to your doors...
Posted: Sat Jul 08, 2006 1:32 pm
by Steven
I have a A1200 Art Series amp running them and i did dampen the doors. I just thought the enclosure would make them perform better. They are not very loud.
Posted: Sat Jul 08, 2006 2:35 pm
by JeremyC
Are you still running all the multiple speakers up front, or did you narow it down to just the Focals?