Page 1 of 1
Distribution Block Question
Posted: Sun Mar 18, 2007 4:55 pm
by thebigo
If I get a distribution block that is one 0-gauge into four 4-gauge, do i need to use all four outputs? Would it be alright if i only used two or three of them?
Posted: Sun Mar 18, 2007 5:04 pm
by Ryan from Ohio
Use what you need. They are there for more options.
Posted: Sun Mar 18, 2007 5:40 pm
by thebigo
Ok, thanks. I was just making sure I could do that... I thought it might have messed it up by not using all the outputs...
Posted: Sun Mar 18, 2007 5:45 pm
by swimmerdude
nahh... its perfectly fine. Like Ryan said, just use what you need.
Posted: Mon Mar 19, 2007 12:08 am
by cargodz
To put into laymens terms... It's like a multiple plug adapter on the end of an extension cord... You can use 1, All, or any where in between :)