Page 1 of 1
"protection mode"??
Posted: Fri May 25, 2007 12:06 pm
by Zach32
My legacy amp is in protection mode, does anyone know what that means? is it dead? lol
Thanks
Zach
Posted: Fri May 25, 2007 12:46 pm
by Bwcad1
protection occurs when the following insue
Thermal overload
incorrect impedance
internal failure
disconnect the speaker wires and turn the amp on if its in protect than its fried.
Posted: Fri May 25, 2007 2:18 pm
by cargodz
Bwcad1 wrote:protection occurs when the following insue
Thermal overload
incorrect impedance
internal failure
disconnect the speaker wires and turn the amp on if its in protect than its fried.
^What Bill said...
Chances are you probably had the gains set to high to try to achieve the maximum performance from your amp... This is death to a Legacy amp... and most amps won't handle it under extended play.
Posted: Fri May 25, 2007 4:01 pm
by loudwagon15s
haha, i briged my crappy legacy to 2 ohm, it didnt like it very much, but still stayed on
Posted: Fri May 25, 2007 7:36 pm
by Darthness
your shit is probably fried son. sorry to hear, it happens. (happened to me)