Attention all members!
Have a cool ride? Then show it off on our website! All vehicles welcome!

My remote wire on my pioneer DEH 8600MP pulled out while removing it from my car

Car stereo head units, EQ, and DSP questions.
Mithrandir
Senior Member
Posts: 799
Joined: Wed Oct 13, 2004 10:30 am

My remote wire on my pioneer DEH 8600MP pulled out while removing it from my car

Post by Mithrandir »

It came out of the harness that connects to the deck, if i by chance cant get a new harness from the factory what can I do to fix this or by pass it so my amps or whoever buys my decks, amps still turn on? Or do you think i can find a diagram of the harness and solder it back inside?
Ryan from Ohio
Posts: 13308
Joined: Fri Mar 17, 2000 12:00 pm
Contact:

Post by Ryan from Ohio »

Well did the wire just break off or did it pull the entire "pin" out of the plug?
-Ryan
www.caraudiocentral.net - Your #1 Car Audio Resource on the Net!
User avatar
MobileAudio219
Master of My Domain
Posts: 4919
Joined: Thu Oct 07, 2004 4:00 am
Location: Sullivan Missouri

Post by MobileAudio219 »

Does it have a power antenna wire??? :D
User avatar
MobileAudio219
Master of My Domain
Posts: 4919
Joined: Thu Oct 07, 2004 4:00 am
Location: Sullivan Missouri

Post by MobileAudio219 »

If it just pulled the "pin" out of the harness, drop it back through. If the wire pulled off the pin, pull the pin out, solder a new piece of wire on, and drop the pin back through.

If the pin/wire both are gone, wire it to the ignition wire? I can't remember if the power antenna wire gets hot with the deck, or when you switch the am/fm on... Might be able to just use that?
loudwagon15s
Senior Member
Posts: 888
Joined: Fri Oct 06, 2006 3:58 pm
Location: Melbourne, Florida
Contact:

Post by loudwagon15s »

you might get lucky, yesterday i went to circuit city, and they had all of their audio accessories out, i found a pin to go into a jvc unit, exactly what i needed. If one is a around, and still open its worth checking out
Mithrandir
Senior Member
Posts: 799
Joined: Wed Oct 13, 2004 10:30 am

Post by Mithrandir »

MobileAudio219 wrote:If it just pulled the "pin" out of the harness, drop it back through. If the wire pulled off the pin, pull the pin out, solder a new piece of wire on, and drop the pin back through.
If the pin/wire both are gone, wire it to the ignition wire? I can't remember if the power antenna wire gets hot with the deck, or when you switch the am/fm on... Might be able to just use that?
I believe it pulled the pin out of the harness, but i have 2 problems. I dont know what empty slot it goes into and It doesnt fit correctly into the harness, ill take a picture and post it.
Post Reply