Amp cutoff

[10k-watts]

So I have 2 psi audio high performance stage 3 18s on a skar audio 3500...amp cuts off when I try to show out and wham out...other than that it plays good and says that hit hard...but if I go up to 15 in volume on those good songs with the lows or that sounding real good it'll cut out...not sure what is going on to make it go in protect

Mr. 10K

[Chris from Washington]

Where do you have your gains set at?

Have you done all the basics, check your grounds and other wiring already?
How are the subs wired?

[10k-watts]

Wired at 1 ohm...gains are low...connections are solid

Mr. 10K

[10k-watts]

I did an adjustment and it's better now

Mr. 10K