Alpine type s or type r 6.5s/ comps or coax?

Mithrandir · Post by **Mithrandir** » Fri Dec 30, 2005 5:21 am

what do you mean nominal 4 ohm for the woofer and 4 for the tweeter? If so ill wire em to an 8 ohm load and give em 75 rms a piece cause im sure they couldnt handle 225 at a 2 ohm load lol

Jonathan · Post by **Jonathan** » Fri Dec 30, 2005 2:08 pm

"what do you mean nominal 4 ohm for the woofer and 4 for the tweeter? If so ill wire em to an 8 ohm load and give em 75 rms a piece cause im sure they couldnt handle 225 at a 2 ohm load lol"

I mean the entire component system is considered a 4 ohm system (b/c 4 is the lowest overall impedance in the set, tweeter may be 8 ohms but if so it won't damage your amplifier). Anyway, you can't wire an 8 ohm load with a 4 ohm component system. The impedance is determined by the drivers and you can't modify that.

Mithrandir · Post by **Mithrandir** » Fri Dec 30, 2005 3:24 pm

ok, then they will be getting 150 rms lol hope they can handle it, ive heard they can

Jonathan · Post by **Jonathan** » Fri Dec 30, 2005 3:27 pm

150W RMS is fine for them.

Jeremy, I'll keep you updated on it if she decides to sell.