Distribution Block Question

thebigo · Post by **thebigo** » Sun Mar 18, 2007 4:55 pm

If I get a distribution block that is one 0-gauge into four 4-gauge, do i need to use all four outputs? Would it be alright if i only used two or three of them?

Ryan from Ohio · Post by **Ryan from Ohio** » Sun Mar 18, 2007 5:04 pm

Use what you need. They are there for more options.

thebigo · Post by **thebigo** » Sun Mar 18, 2007 5:40 pm

Ok, thanks. I was just making sure I could do that... I thought it might have messed it up by not using all the outputs...

swimmerdude · Post by **swimmerdude** » Sun Mar 18, 2007 5:45 pm

nahh... its perfectly fine. Like Ryan said, just use what you need.

cargodz · Post by **cargodz** » Mon Mar 19, 2007 12:08 am

To put into laymens terms... It's like a multiple plug adapter on the end of an extension cord... You can use 1, All, or any where in between :)