Attention all members!
Have a cool ride? Then show it off on our website! All vehicles welcome!

kinetik batt

Anything not related or doesnt fit another Forum.
hardtymermiata
Junior Member
Posts: 29
Joined: Mon Apr 26, 2010 7:31 am
Location: upstate south carolina

kinetik batt

Post by hardtymermiata »

a couple months back i picked up a kinetik hc 2400 for a good price from a friend . he let me barrow his charger to recharge it . got it charged & installed about 2/3 weeks later it needed to be recharged so i picked me up a charger (not the same as his) and tried it . nothing , nada . i'm waiting on him to get back in town so i can find out what kind of charger he has . but i do know the charger i have will charge my hc 600 .
loudwagon15s
Senior Member
Posts: 888
Joined: Fri Oct 06, 2006 3:58 pm
Location: Melbourne, Florida
Contact:

Post by loudwagon15s »

why would it need to be recharged? Your alternator should be taking care of that.
hardtymermiata
Junior Member
Posts: 29
Joined: Mon Apr 26, 2010 7:31 am
Location: upstate south carolina

Post by hardtymermiata »

i thought the same thing . but one morning after work i had to get a jump start . got home checked all wires going to and from the battery tightened any lose conections . tried to start the car and everything worked fine the car started . problem solved so i thought . later that night i was getting ready to start the car and would you belive it was dead again . not sure if this matters or not but i was using it as a secondary battery . had to baroow a car to get to work that night . when i had some time i went through and run everything back off my main battery and just reomved the 2400 . if i could get it charged i would try it as the 1 and only battery to see if it was just too much for my alt to try and charge 2 batterys ..
loudwagon15s
Senior Member
Posts: 888
Joined: Fri Oct 06, 2006 3:58 pm
Location: Melbourne, Florida
Contact:

Post by loudwagon15s »

it wont be too much unless its bad....start your car and put a voltmeter on it to make sure its getting 13.5+ volts, 14+ would be better and with everything off see what voltage its sitting at. Then put a decent load on it with everything off (amplifiers playing) and see what the voltage drops to, or just take it to autozone and have them test it
hardtymermiata
Junior Member
Posts: 29
Joined: Mon Apr 26, 2010 7:31 am
Location: upstate south carolina

Post by hardtymermiata »

thinks i'm gonna try that . my buddy said he had to charge it every once in a while too . but i didn't lose too much money on the deal if it is bad so not gonna be upset .
Bwcad1
Master of My Domain
Posts: 9312
Joined: Wed Aug 03, 2005 11:00 am
Location: Ohio

Post by Bwcad1 »

hardtymermiata wrote:thinks i'm gonna try that . my buddy said he had to charge it every once in a while too . but i didn't lose too much money on the deal if it is bad so not gonna be upset .

are you running an isolator?

give us a run down of your electrical system including connections.
ImageImage


ΜΟΛΩΝ ΛΑΒΕ
Post Reply