Mmats hc100d

OnYrMrk · Post by **OnYrMrk** » Mon Apr 17, 2006 11:39 am

I figured as much...no skin off my rear...

High Society · Post by **High Society** » Mon Apr 17, 2006 12:24 pm

http://www.rockfordfosgate.com/rftech/w ... 4+ohms+x+2

This is how you wire it up for a 2 ohm load.

donpisto · Post by **donpisto** » Wed Jun 14, 2006 9:38 am

jejuanm wrote:I have a Mmats hc 100d, Anyone know what the this amp will do at .05 ohms. Also is it worth running it at .05 ohms. I have have 4-12" DVC 4 ohm ratings. I wondering if this amp will do the job, or do i need another amp. I have a Autotek MX5000 but i had to take that beast out of my explorer, it was killing the electrical system. So im looking for some great input here, and the subs are Kicker
L series.

I'm not sure what it would do at .5 ohms but I dont recommend running it at .5 ohms, even though the mmats can get that low. any time you decrease the ohms, your increasing instability. amps are more stable at higher ohms. I guess if you dont push it too much then you would be fine, but be careful, if the ohm level drops below .5 often say goodbye to the amp

Bwcad1 · Post by **Bwcad1** » Wed Jun 14, 2006 9:41 am

no offence dude but these posts are really old.