I dont know

nist7 · Post by **nist7** » Mon Apr 11, 2005 5:38 pm

actually, not sure at all, lol.

the sound storm lab website had very little specs on the amp. so you're probably right. my alpine amp is also only stable at 4-ohms when bridged...

ridr4lif · Post by **ridr4lif** » Mon Apr 11, 2005 6:39 pm

Ok...well since i didnt see what amp you had before, i would wire them at 8 ohms and be safe. OR, get a new amp that is stable to 2 ohms

TEDD

Mitsu · Post by **Mitsu** » Mon Apr 11, 2005 7:34 pm

ok thanks alot i dont want to toast my setup especially since i just got it.

Mitsu · Post by **Mitsu** » Wed Apr 13, 2005 10:27 am

i was reading through http://www.bcae1.com and i havent finshed, but i had a question about watt rating on speakers if my speakers say 700 Watts, 4 ohm does that mean it can handle 700 watts of power with 4 ohms resistance?

Ryan from Ohio · Post by **Ryan from Ohio** » Wed Apr 13, 2005 10:50 am

Depends... On if your talking RMS or MAX, two very different beasts.

RMS is an applied power rating that is due to thermal reasons.

MAX is applied as a "theoretical" number. MAX power is rarely ever seen and when it is it is so quick...

The specs on the subwoofer probably are 700 WRMS and the sub is a 4 Ohm driver.

William from NOLA · Post by **William from NOLA** » Wed Apr 13, 2005 11:46 am

Typically on cheaper speaker companies, they post the max rating all over their subs (and amps if they make those) just to get people to buy it. Then they realize that the speaker can only handle like 100 watts RMS when they advertise say 600 or 700 watts.

Post by **GlassWolf** » Wed Apr 13, 2005 4:32 pm

4 ohms is the nominal impedance of the speaker. that is a fixed value.

700 watts is a measure of how much heat the voice coil of the speaker can handle without thermal damage. this isn't an indication of how much power the speaker actually needs though. usually you can use less than the RMS power handling value of the speaker and still get peak output.